Cisco.IOS fix get_interfaces rx_sh_int for management port
Example of output show interface command:
GigabitEthernet0/0 is up, line protocol is up
NOTE: Packet counters for management port are meaningful
only when it is physically located at stack master
Hardware is RP management port, address is 707d.b903.7b80 (bia 707d.b903.7b80)
Description: descr-INT-Gi1/1/1#MonStat
Internet address is 10.10.111.1/28
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full Duplex, 1000Mbps, link type is auto, media type is 100BaseTX
output flow-control is unsupported, input flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 2000 bits/sec, 2 packets/sec
5 minute output rate 10000 bits/sec, 2 packets/sec
153573918 packets input, 15643192614 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
96214052 packets output, 24764607416 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
1 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out